Parting out M1008 and M1031 CUCV trucks, Ford 60 front

[DrJekl]

I'll be getting two CUCV trucks soon and will be clubbing them in the head. Parts available will include:

CUCV radiator $125
Dana 60/14 bolt combo, 4.56 gears, detroit in the back, open front, 45K miles. Front is complete lock out to lock out $1500
Same but limited slip front $1800
http://cjcs-supply.com/JeepForSale/p_00178.jpg
Chevy truck cab in good shape with clear TN title. Two available now and one is waiting on the TN title to come back. Assume them to be stripped of the doors, dash and seat. $300 each
GM 6.2L diesel engine, complete minus starter and power steering pump. $400
HD TH400 and NP208 combo $450
HD TH400 and NP205 combo $SOLD
1 ton springs M1028/M1031 with the helper spring on top of the spring pack $100
Front and rear bumpers with brush guard in front $200
Front grill $50
Bed in good shape, no rust but dented $SOLD
Fenders $50 each
Maintenance bed $SOLD
13K generator head $500 (two available)
Steering column with key $50
Gauges $25
Glow plug control card $200
Lots of other misc parts.
M1009 Blazer K5 top $50
Radiator support $25
Hood $50
Radiator $100



Not available:
Doors (I have door guts but no good doors), dash,


Other parts/items:
HMMWV wheels with tires. Removed from M116 trailers. I do not believe these have run flats in them. Tread is deep. 16.5x37" radials. Wheels are tan or black. $100 each, like new.

King pin Ford 60 DRW front from 88 F350, 4.10 gears. Complete lock out to lock out but will need new rotors and calipers. $800

1.5 ton military trailers $300-600 depending on accessories and condition. Even the beaters are in pretty good shape.
1.5 ton M332 ammo trailer in very good condition, new paint, OD green $400
1.5 ton M332 ammo trailer, rusty paint but solid $300
3/4 ton military trailers $400-600


Offers and trades considered. Located near Linton, KY. Photos available on request. Please IM or email me your request with a good return email. drjekl at cjcs-supply.com

[lilredxj99]

I'd love to get one of these complete, but aren't they going pretty high still?

I would like to have a running blazer w/ the dana60/14bolt & 37's for a good hunting vehicle.

[DrJekl]

Depends on the auction. Photos don't tell the whole story. The pretty ones on the most recent auction I was looking at were in the worst condition in regard to the running condition. One of the best ones went for less than some junk. Some went high but had 10 bolt front axles in the 1031 and 1008 series. The M1009 Blazers were way over priced. $1200 for junk you can't recover your money in as they were $300 vehicles hands down. 1008s went from $1500-2500 and ranged in condition and completeness. Location matters too. SOme places the vehicles are dirt cheap and others they go high.

[DrJekl]

BTT.

I have the vehicles on hand. two trucks run just fine and I'll be pulling the axles from them and installing 3/4 ton running gear and selling the trucks whole. They're too good to club in the head. The third has some wiring issues and I am not sure how deep I'll need to go to make it road ready. I think it will be clubbed in the head.

All three vehicles will have clean TN titles in about 4 weeks so if you need a pretty solid old Chevy truck cab and chais with good title, I'll have what you need. Three sets of 60/14 bolts with open front, 4.56 gear, detroit in the rear are available.

[DrJekl]

BTT again.

[DrJekl]

Due to lack of time to make these into 3/4 tons I am parting all but one out. The one truck looks and runs good, has 4.10 gears now. $2500.

[DrJekl]

back to the top.

[DrJekl]

Photo added.

[DrJekl]

2 D top.

[DrJekl]

Down to one set of axles. TH400s and 205s sold.

[DrJekl]

Bump

I have a newly rebuilt TH400 from a HMMWV. As you may know, these have the heavy duty guts and no park. Park guts installed and rebuilt. Decided to go with a 700R4 instead. $500

[DrJekl]

Just pulled in a M1031. 60 front and 14 bolt rear, limited slip front, detroit in the rear, 4.56 gears. $1600 for the set.

Also have a new set of axles out of the crate. $2500 for the set.

New NP205 case $700

trans is either new or rebuilt,

engine has new lift pump, new injector pump. Body looks good. 13KW generator head.

[PDK]

Willing to trade the Chevy 60 front for a 60 front out of an 02 F350?
I no longer need the Ford and need a Chevy 60/14.
David