PDA

View Full Version : Door question...

ih8pepl73
10-05-2008, 01:32 PM
I think the top part of my driver's door is bent. Right at the rounded part of the door, there's an air leak. I can push the door from the outside, there's about an 1/8" gap.

ANY IDEAS??????
FLIP THIS
10-05-2008, 02:15 PM
Weld it shut? Dukes of Hazord that baby!
ccjc1397
10-05-2008, 04:58 PM
Do you see any chipped paint or rusted areas? I don't have full door on my jeep but can you adjust the hinges or anything. At work we "fix" hummer doors with a slight gap with lots of RTV or double bubble, LOL.
belltom
10-05-2008, 06:55 PM
I think the top part of my driver's door is bent. Right at the rounded part of the door, there's an air leak. I can push the door from the outside, there's about an 1/8" gap.

ANY IDEAS??????

We used a porta-power at an angle from one corne to the other to correct this with Denise's Jeep. Just take it slow, do a little at a time.
ih8pepl73
10-05-2008, 06:57 PM
Do you see any chipped paint or rusted areas? I don't have full door on my jeep but can you adjust the hinges or anything. At work we "fix" hummer doors with a slight gap with lots of RTV or double bubble, LOL.


No paint chips or rust. I was thinking more if the door-catch is adjustable. If I can't bend the door back, I was thinking of using garage door weatherstripping.